6-Реле и 8 входов управление умным домом (Tasmota) Ethernet+WiFi

Цветная схема.V3-Tasmota-MQTT-Ethernet-Module-6relay-COLOR

template {“NAME”:“WT32-ETH01”,“GPIO”:[1,1,1,1,1,1,0,0,1,0,1,1,3840,576,5600,0,0,0,0,5568,0,0,0,0,0,0,0,0,1,1,0,1,1,0,0,1],“FLAG”:0,“BASE”:1}

Также можно установить и просто Wi-Fi модуль ESP8266.

DipTrace Schematic – ESP-12E-replace-WT32-ETH01-V3

p.s. AIN1 – при установки WiFi модуля отсутствует.

backlog SetOption36 0;SetOption65 1;wificonfig 4; SetOption59 1

Реле

backlog sensor29 0,5,0; sensor29 1,5,0; sensor29 2,5,0; sensor29 3,5,0; sensor29 4,5,0; sensor29 5,5,0

Входы

backlog sensor29 8,2,1; sensor29 9,2,1; sensor29 10,2,1; sensor29 11,2,1
backlog sensor29 12,2,1; sensor29 13,2,1; sensor29 14,2,1; sensor29 15,2,1

rule
on event#MCPINT_D15=1 do power0 on endon on event#MCPINT_D15=0 do power0 off endon
on event#MCPINT_D14=1 do power0 on endon on event#MCPINT_D14=0 do power0 off endon
on event#MCPINT_D13=1 do power6 on endon on event#MCPINT_D13=0 do power6 off endon
on event#MCPINT_D12=1 do power5 on endon on event#MCPINT_D12=0 do power5 off endon
on event#MCPINT_D11=1 do power4 on endon on event#MCPINT_D11=0 do power4 off endon
on event#MCPINT_D10=1 do power3 on endon on event#MCPINT_D10=0 do power3 off endon
on event#MCPINT_D9=1 do power2 on endon on event#MCPINT_D9=0 do power2 off endon
on event#MCPINT_D8=1 do power1 on endon on event#MCPINT_D8=0 do power1 off endon

Включить правила.

rule 1

p.s. Перепрошивка:

  1. Замкнуть BOOT
  2. Подключить основное питание
  3. Подключить USB
  4. Залить новую прошивку.

esptool.py –chip esp32 –port /dev/ttyUSB0 –baud 115200 –before default_reset
–after hard_reset write_flash -z –flash_mode dout –flash_freq 40m
–flash_size detect 0x1000 ../bootloader_dout_40m.bin 0x8000 ../partitions.bin
0xe000 ../boot_app0.bin 0x10000 .pio/build/tasmota32/firmware.bin