Tasmote MQTT ESP8266 8xRelay Module

8-Relay-Tasmota-Ver-1-0-Подключение (PDF)

Schematic_MQTT-Relay-8_2021-04-05

Настройка Tasmota (MCP23017) 16 Input/Output Ports

# Port D0-D7 OUTPUT

backlog sensor29 0,5,0; sensor29 1,5,0; sensor29 2,5,0; sensor29 3,5,0
backlog sensor29 4,5,0; sensor29 5,5,0; sensor29 6,5,0; sensor29 7,5,0

# Port D8-D15 INPUT

backlog sensor29 8,2,1; sensor29 9,2,1; sensor29 10,2,1; sensor29 11,2,1
backlog sensor29 12,2,1; sensor29 13,2,1; sensor29 14,2,1; sensor29 15,2,1

# Enable for binary Sensor

HOME ASSISTANT TIPS:
You can use SetOption59 1 in order to get extra SENSOR status telemetry messages in addition to event-triggered RESULT messages. This allows very good integration with Home Assistant because it needs to monitor only one payload for both periodic and instant messages using.

# Binary Sensor

binary_sensor:
– platform: mqtt
  name: “MCP23017 Test D8 SENSOR”
  state_topic: “tele/tasmota/SENSOR”
  value_template: “{{ value_json[‘MCP230XX’].D8 }}”
  payload_on: “1”
  payload_off: “0”
  availability_topic: “tele/tasmota/LWT”
  payload_available: “Online”
  payload_not_available: “Offline”
  qos: 0
 device_class: door

# Rule – Правила для включения реле при появления сигнала на входах.

rule
on event#MCPINT_D15=1 do power8 on endon on event#MCPINT_D15=0 do power8 off endon
on event#MCPINT_D14=1 do power7 on endon on event#MCPINT_D14=0 do power7 off endon
on event#MCPINT_D13=1 do power6 on endon on event#MCPINT_D13=0 do power6 off endon
on event#MCPINT_D12=1 do power5 on endon on event#MCPINT_D12=0 do power5 off endon
on event#MCPINT_D11=1 do power4 on endon on event#MCPINT_D11=0 do power4 off endon
on event#MCPINT_D10=1 do power3 on endon on event#MCPINT_D10=0 do power3 off endon
on event#MCPINT_D9=1 do power2 on endon on event#MCPINT_D9=0 do power2 off endon
on event#MCPINT_D8=1 do power1 on endon on event#MCPINT_D8=0 do power1 off endon

backlog SetOption36 0;SetOption65 1;wificonfig 4; SetOption59 1