Ноя 052022
 

Дополнительные модули.

ZigBee E18-MS1-PCB/IPX (https://ptvo.info/cc2530-based-zigbee-coordinator-and-router-112/)

Маркировка на плате R1 и R3 – перепутаны !!!

E18-MS1-PCB-Module-Romik-V1.0 (Схема) Schematics

https://ptvo.info/cc2530-based-zigbee-coordinator-and-router-112/

R1,R2 – Запаять для использования порта P0.2(RX),P0.3(TX) как UART
R3,R4 – Запаять для использования порта P1.4(RX),P1.5(TX) как UART
Одновременно запаивать не нужно.

Программирование модуля: https://zigbee.blakadder.com/flashing_ccloader.html

P.S. External sensor power control – it is a special output type. The firmware sets the configured output to the HIGH state before reading a sensor’s value, and sets it to LOW after that. The CC2530 and CC2531 chips allow you to use pins P10 and P11 to supply power up to 20 mA to external sensors.

https://ptvo.info/zigbee-configurable-firmware-features/power-saving-mode/

 Posted by at 14:28

  One Response to “Дополнительные модули ZigBee E18-MS1-PCB”

  1. […] Дополнительные модули. […]

Sorry, the comment form is closed at this time.